Wanted Getrag 284 front and rear input bearings

[Cidacious]

I was hoping someone had a good spare front and rear input shaft bearing they would be willing to sell me. I think the rear needs to come with the carrier and seal, but not sure you would know better.

[Cidacious]

After much debate I figure this is the most appropriate place for this follow up question rather than making a new thread in the transmissions forum. If you guys think it should be there let me know. I have read perhaps here but maybe somewhere else that many bearings have numbers stamped to them that crossreferences to universal bearings that can be bought from numberous bearing companies. Has anyone gone down that road with their 284? If someone has, i would really appreciate any info on how that went, or even like borg warner part numbers or something. Thanks guys!!!

[94GPGTP]

i have a whole 284 that has bad 1st and 2nd.. when drain plug was removed there was shavings on the magnet.. if any intrest LMK.

[Cidacious]

What does the metal shaving thing mean on the magnet? Mine had a very thin layer of metallic goo on mine, is that something to be alarmed about? I am interested in your bearings if it wasn't making any noise when you pulled the trans. How much would you sell them to me for?

[94GPGTP]

It had the goo stuff on the magnet too but also a shaving of probably a chipped gear since the syncros for 1 and 2 were bad. I would like to just get rid of the whole thing. Indy isn't too far from me. 2.5 hours away.

[Cidacious]

How much would you sell your whole 284 for then?

[94GPGTP]

Make offer