My 3400 build!

[19Cutlass94]

I did....


Got the pushrods today and the heads pushrods and rockers will all be going on tomorrow! Just wish I had the parts back from powdercoating

[mbear2489]

i would like to inform you of your bastardlyness as that was the motor i was gonna get before my coolant hose exploded and my funds depleted for other things. treat her well lol

[19Cutlass94]

LOL!

Im sorry! But dont worry... shell get put to good use! haha

[mbear2489]

hahaha good good. thats alright. i'll find a new guinea pig...

[19Cutlass94]

Quick question... the studs on the rockers.. I looked at the spec and it said tighten them 14ft-lbs + 30degrees... That sounds like a strech bolt. Should I be replacing these? Or just run with the ones that I have?

[19Cutlass94]

nvm... found my answer

[19Cutlass94]

This is what I can get done until my powdercoated parts are done.

[zofo61]

Looks like you are getting along quite well...........what color are the powder parts going to be?

[El_Diablo]

...And currently, the intakes and other odds and ends are at powdercoating. Im getting the intakes in silver, 3400SFI in body color, and a few brackets in silver and black.

from post #1...

[zofo61]

tanks

[El_Diablo]

that engine is getting put to good use over what matt would've used it for, it didn't deserve to stay stock, it was just to beautiful

[mbear2489]

hahah
fair enough. im geting a large port 3100 springtime i think. my dad and i will drop it in.

[19Cutlass94]

haha I cant wait to get these intakes back... I hate waiting for parts!

The large port 3100 should work pretty good for ya.

[mbear2489]

yep. easier swap. very straight forward. i like simplicity

[19Cutlass94]

So is the 3400. Just a couple minor differences