Tweet
As the subject states, I'm looking to do a full rebuild on my L82 3.1 once Spring hits. It's got a bit of a 'tick' (could be a rod or a lifter, not 100% sure which), so I want to do a motor swap and then rebuild the original. Can anyone give me a parts list I'll need so that I can start getting some prices now. I'm a slight amateur, so I don't know exactly what everything is called, especially the little things. All help is greatly appreciated.
-
-
Its most likely a lifter. A rod would be louder and vary with engine load more so than just RPM. Is this a stock rebuild or are you looking to upgrade it any?Ben
60DegreeV6.com
WOT-Tech.com -
^ some people may call this guy an asshole at times, but he isn't wrong very often -- RobertComment
-
Good book... however, while it barely touches on the Gen II engines, it has absolutely nothing about Gen III (roller cam, etc...) Unfortunately by the time the L82 3100 came around, the 60* was relegated to utilitarian status.Originally posted by Schurkey View Postsigpic
"When you don't do anything, you have plenty of time to post questions that don't mean anything tomorrow."
- BenComment
-
To give you a parts break down, it would be best to pick up a service manual (not the typical Haynes-Chiltons book) and thumb through it.
3.1 LH0 is not a 3100 L82, however this section is for the LQ1.Lifting my front wheels, one jack at a time.Comment
-
Did I miss something? The OP states L82 3.1 and this is the Pushrod Maintenance section...Originally posted by 1988GTU View Post
Has the OP posted about this project elsewhere as well?sigpic
"When you don't do anything, you have plenty of time to post questions that don't mean anything tomorrow."
- BenComment
-
You missed that it was moved from the DOHC section to here.Lifting my front wheels, one jack at a time.Comment
Comment