Starting Issue after complete car rebuild.

[Darin]

Ok, I put my 94 Grand Prix back together, and I am having what I think is some kind of security problem. (note this car was completely torn apart and re assembled)

When I turn the key on everything powers up. and the car will not crank. If I leave the key in the run position and jump the starter then it will start but dies only a second later. Is something shutting the injectors down?

What I am getting at is there something that i need to do to "reset" some kind of security?

[bszopi]

http://www.bsecorp.com/files/techtips/ST9303l.pdf

Maybe?

[Darin]

Thanks Brad, I will let you know in about 45 mins! LOL

Passkey 2 relearn.

1. First, insert the ignition key and
turn the ignition switch to the
“On” position (Do not start the
engine). Leave the switch on for
11 minutes. The security light
may flash or be on steady during
this 11 minute period. Make sure
the light is no longer on or
flashing before proceeding to #2 .
2. Turn the ignition switch off for 30
seconds.
3. Turn the ignition switch to the
“On” position (as in step #1) for
11 minutes again.
4. Turn the ignition switch off for
another 30 seconds.
5. Turn the ignition switch to the
“On” position for 11 minutes a
third time.
6. Turn the ignition switch off for 30
seconds one final time.
7. Turn the ignition switch to the
“On” position one final time and
wait 30 seconds.
8. Attempt to start the engine.
If the engine starts and runs
normally, the relearn is
complete.

[Darin]

That didnt work....

[Darin]

Problem solved.

[bszopi]

And you aren't going to tell us the answer?

Oh BTW, welcome back...

[Darin]

It was my mistake, I used the wrong VAT module.