Where's a good source for performance parts ?

[TimWhittaker]

Looking for some good information on performance parts for these engines. Where to buy, etc.
How difficult is it to get 230 - 250 Hp without breaking the bank ? Thanks in advance.

[Doubt_Incarnate]

it almost depends on your motor. youre the guy building a stalker, so whichever motor you get will sort of determine how much its gonna cost. if you get an 3400sfi you have 175hp to start with, the rwd 3.4 from the camaro's were about 160. the roller cams for the 3x00 motors dont interchange with the older or rwd motors. i know crane sells a few cams and some locks and retainers for the iron heads. i'd have to think a carbed rwd 3.4 with a set of good headers and a nice cam will get you over 200hp N/A reletivly inexpensively. boost is king of power, a good FI turbo or supercharged setup will make more power throughout the entire rpm range, and can be done on a budget. it depends on what you want.

https://www.jegs.com

https://www.summitracing.com

those are 2 places off hand. so far my project has a little over $2000 in it.
thats the cost of the motor, machineshop services, all new valves and their related stuf, a cam, 1mm oversize pistons, total seal rings, new bearings, gaskets, etc. and its a fwd MPFI motor, should be right around 200hp, but it doesnt have headers.

[geoffinbc]

http://www.gmgoodwrench.com/perfpartsjsp/subcategory.jsp?cat=9269&section=ep

https://www.cranecams.com

https://www.compcams.com

https://www.msdignition.com