If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
proceed to the Forums area and select the forum that you want to visit.
Have to change the intake manifold on a 3.1, can't cut intake gasket, have to remove the push rods, how do you adjust the valves after changing the gasket?
Comp Cams has a great writeup on adjusting lifter preload. However their instructions will say to just add 1/2 turn. This is not enough for factory studs you need to add at least 1 turn after you find zero lash.
The instructions are best found by looking up rocker arm installation instructions.
Comment