'92 4t60e tranny pull

[Gunboat]

Ok,I've finally gotten all of the bolts out of the car so that I have the sub frame dropped...bolts are out of the bell housing,engine to tranny mount is undone,now,do I have to totally drop the whole sub frame to get the tranny out? it doesn't seem like it's wanting to move,there is a space between the bell housing and the engine,what am I missing here? This is my first front wheel drive job,I have done plenty of rear wheel pulls...both axles are pulled,there isn't anything else that I can see that needs to be removed to get this thing out,any and all suggestions are welcome...just need a little help.. thanks in advance...

[pocket-rocket]

There is a bracket between the tranny and engine at the diff housing on the passenger side. The way the engine/trans is supported I don't see a way to remove it without pulling the subframe unless you went out the top. Hope this helps.

Sent from my HTC One X using Tapatalk 2

[1988GTU]

There is one bolt going from the engine to the trans.
Not the same trans, but same concept:

[Gunboat]

thanks,guys,I was "hoping" not to have to totally drop the sub frame,and yes,I did get that back bolt...damn,this thing has been a pain in the ass,wish I'd have just paid the 400 bux to have it done,thanks again..