Tweet
Hello again.
Just wondering if there was a place on the site or anywhere that has the engine dimensions and other information. I have searched the site already.
The reason for me asking is that I have a Toyota Celica ST I have been waiting to turbo or swap. And with the cost of a swap (250WHP) or turbo (200WHP) I believe I could get a whole standalone unit and see if a 3.1 or 3.4 would fit in the engine bay.
A friend has swapped a whole V-6 out of a Toyota mini-van into his and had enough room. And the fact that these engines were also a cross breed with GM (GEO used the 7AFE and a three cylinder counterpart) and the narrow cross section leads me to believe that with some engineering this could be done.
Leading to a NA car that can put down 200+ WHP and still tip the scales at just over 2K.
Thoughts and ideas are greatly appreciated.
Just wondering if there was a place on the site or anywhere that has the engine dimensions and other information. I have searched the site already.
The reason for me asking is that I have a Toyota Celica ST I have been waiting to turbo or swap. And with the cost of a swap (250WHP) or turbo (200WHP) I believe I could get a whole standalone unit and see if a 3.1 or 3.4 would fit in the engine bay.
A friend has swapped a whole V-6 out of a Toyota mini-van into his and had enough room. And the fact that these engines were also a cross breed with GM (GEO used the 7AFE and a three cylinder counterpart) and the narrow cross section leads me to believe that with some engineering this could be done.
Leading to a NA car that can put down 200+ WHP and still tip the scales at just over 2K.
Thoughts and ideas are greatly appreciated.
Comment