WTB: Cam cogs off a 1994-1995 3.4

[PHILBERT]

Does anyone have some cam cogs from the 1994-1995 3.4 they can sell? Ben/Vegeta told me I should look to acquiring some for my car. Long story. Anyway, if anyone has some they don't need, drop me a line please.

[your_I.D.]

I have 4 extra cam cogs.

[PHILBERT]

And they are the same for the 94-95 3.4? How much would you be looking for them? Thanks.

[PHILBERT]

*sneeze*

[pepsi_coke]

God Bless You

[PHILBERT]

Thank you.

[your_I.D.]

pm'd ya

[PHILBERT]

Thanks. Do you also have a picture of them as well you could post?

[your_I.D.]

Sorry for the delay.

[RollinonZ34]

Not to stray from the subject but...

The Pix that you put up show the Cog with the Rounded slots that
the Cam Gear Holder goes into. I also have the 94 motor with these
same Cogs, but the Cam Gear Holder that i bought (J 38614) does
not fit, as it seems to be made for the older Cogs where the slots look
to be more square. I even grounded the edges on the tool to help it
fit better into Cog but did not help. So i ended up just breaking bolts
loose with Cam Flat Tool on...that i hear is a bad thing, as it may damage
threads that Flat tool bolts down to.

Anyone have a better idea as to what i can do to make my tool work
on the Newer Cog with rounded slots as i need to redo timing in the
near future.

Thanks, Paul

[your_I.D.]

I'll post a pic later of my cam cog holding tool. (homemade)

[RollinonZ34]

Cool...I did not realize that i was posting this in the Buy/Sell area
until after i posted it...therefore realizing that you two would probably
be the only ones to see my question... your link was on the side of homepage (the few current ones on the right) ....duuaaaa.

Anyway, thanks for any ideas if u got the time to show pix...Paul