Tweet
I've gotta drive my car to TN next week and I installed the original set before driving to Colorado... I will not do that again so mine will be waiting till after I go on my car show trip. Might not happen till this winter if I pull the motor and then get some miles on it next year to see what it does.
-
Got Lope?
3500 Build, Comp XFI Cam 218/230 .050 dur .570/.568 lift 113LSA
Fully Balanced, Ported, 3 Angle Valve Job, 65mm TCE TB, S&S Headers.
Stage-1 Raybestos/Alto 4t60e-HD, EP LSD, 3.69FDR
12.61@105 Epping NH Oct 2015 Nitrous 100shot (melted plugs) 13.58@98.8 N/A 3200LBS -
Hey guys getting back into my project and having alot of trouble finding the directions on how far to groove the cover for the DRTC. Can someone post the link if they have it? Any suggestions on how you guys did it would be greatly appreciated also!Comment
-
Kit should have included depth gauges... I had mine milled down on a bridgeport.
Got Lope?
3500 Build, Comp XFI Cam 218/230 .050 dur .570/.568 lift 113LSA
Fully Balanced, Ported, 3 Angle Valve Job, 65mm TCE TB, S&S Headers.
Stage-1 Raybestos/Alto 4t60e-HD, EP LSD, 3.69FDR
12.61@105 Epping NH Oct 2015 Nitrous 100shot (melted plugs) 13.58@98.8 N/A 3200LBSComment
-
O damn must have lost my gauge in the whole mess of a group buy this was. Anyone have an extra one or measurements? Just want to finally get this motor done!Comment
Comment