Announcement

Collapse
No announcement yet.

Wtb tce drtc!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1988GTU
    replied
    Yes, would have been out on gaskets, bearings, and then machine $ not even factoring in my labor.

    Leave a comment:


  • 3400-95-Modified
    replied
    Modified or not it still works, it would just be cost of the work you would be out on... I'm running the modded crank in mine right now with a factory chain. If done right it only adds chain clearance and doesn't modify where the sprocket runs.

    Leave a comment:


  • 1988GTU
    replied
    My motor is sealed up with fresh gaskets. Luckily the spare crank I had hasnt been modified yet.

    Leave a comment:


  • 3400-95-Modified
    replied
    I wish there was something to say about this other than I'm completely pissed off at the lack of communication on TCE's side of this. No update in over 2 months when he said he was close to a resolution is ridiculous...

    Leave a comment:


  • Sleepyalero
    replied
    I know its a little dead thread atm. Just stopped in to say I dropped mine off to milzy last week while I went out to his shop. Mine I wanted looked over. And will have oil slots added on the cam sprocket since it didn't have it.

    Sent from my SCH-I605 using Tapatalk

    Leave a comment:


  • 3400-95-Modified
    replied
    If you got the previous email from him I can only assume you will get another when he has an update. I don't think asking here really helps anything unless you never got the latest update. He doesn't look at this forum anymore to my knowledge.

    Leave a comment:


  • 1988GTU
    replied
    Nothing on my end.

    Leave a comment:


  • Kaiju Senso
    replied
    Any updates?

    Leave a comment:


  • young gun
    replied
    Originally posted by ericjon262 View Post
    PM me your email address and I will forward it too you.
    Originally posted by 3400-95-Modified View Post
    I pm'd him the email.

    Thanks guys.

    Leave a comment:


  • ericjon262
    replied
    Originally posted by 3400-95-Modified View Post
    I pm'd him the email.
    thanks

    Leave a comment:


  • Kaiju Senso
    replied
    I'm glad to have heard an update. I don't mind waiting because my engine needs a new top end now anyway...

    Leave a comment:


  • 3400-95-Modified
    replied
    I pm'd him the email.

    Leave a comment:


  • ericjon262
    replied
    Originally posted by young gun View Post
    I did not receive one
    PM me your email address and I will forward it too you.

    Leave a comment:


  • young gun
    replied
    Originally posted by ericjon262 View Post
    to everyone involved in the group buy, check your email. I received a reply from Marc, I'm not going to post the reply here for privacy reasons, but it appears to have been sent to most, if not all of the buyers.
    I did not receive one

    Leave a comment:


  • ericjon262
    replied
    to everyone involved in the group buy, check your email. I received a reply from Marc, I'm not going to post the reply here for privacy reasons, but it appears to have been sent to most, if not all of the buyers.

    Leave a comment:

Working...