Wanted 3.4L Throttle Body Intake Manifold

[noyb43]

Building a 3.4L to install in an MGB. Need an intake manifold that will accept a throttle body. Text eight one two-three four three-zero four six eight.

Thanks!

[alpinestar10]

I have a 3400 intake off a 2000+ 3400 im not using its been powdercoated black and still looks good 25 + shipping sound good?

[noyb43]

unsure if this will fit a 1994 3.4L out of a Pontiac Firebird. Your thoughts?

[alpinestar10]

Unless you swap to a 3400 topend no it wont fit that engine. Sorry.

[2.8/3400 1985 Camaro]

Noyb43, you are looking for just the plenum, from a rwd 3.4 fbody? Or TB and LIM as well? And 2ndly is there any chance you have the whole car you pulled that engine from, if you aren't running the ECM and harness that went with that engine I'm trying to track down a pair and might be interested in trading with some cash in your favor (if you're just after the UIM). I'm not quite sure I would want to outright sell it though...I don't need it per say, but its better than my 2.8 manifolds.

[noyb43]

just need the plenum.

[CNCguy]

Noyb43.... Do you mean the upper intake for an SFI engine where the TB points forward towards the radiator? Or are you wanting a TBI intake which is similar to a carb intake and the TB sits in the center pointing upwards. Not that I have either but trying to make sure everyone knows exactly what you are looking for.