Heads, Crankshaft, Block, Cam Pictures Posted

[NateD4]

http://img13.imageshack.us/slideshow...=dscn0999r.jpg

I had a lot of responses for the port and polished heads, block and reground cam.

I have posted pictures for most of the items from the 3400 engine I am selling.

The engine is available rebuilt if anyone is interested in a ready to run engine.

If not I will be parting the engine out.

I have two of the following parts:

Heads
Crankshaft
Piston and Rod Sets
Oil Pans
Oil Pumps
timing chains
intake manifolds
fuel rails and injectors
throttle body
valve covers
etc...

I basically have parts from to 3400 LA1s except one of them the block was bad so I am selling the remainder of the parts.

Let me know if you have any questions.

Make offers on any parts you are interested in. Just tell me which image number and how much.

[95Grand-Am]

Do you have the cam spec and how much do you need for it?

[beastberetta]

how much for the fuel rail and injectors and also fpr if you have it? and a price for the exhaust manifold with crossover shipped to 46323 thanks.

[Rootie524]

how much for ported heads?

[NateD4]

Camshaft specs are:
Clay Smith Cams:
HR-260-12-R 210 @0.050

I'll call them today to get the exact decoding of their markings.

_________________________

Exhaust manifolds: make me an offer. Shipping should be less then $45. Again make me an offer and then I can get you some more accurate shipping numbers.

[GrandAmGTTT]

how much for ported heads?

X2 and whats the size of the combustion chamber and how much were the heads ported bc you said there were differ levels or port between your differ sets.......need more info please!

[alpinestar10]

Where are you located?

[trotterlg]

Did you get the cam specs? They are closed on Friday, what kind of performance did you get out of it? Larry

[NateD4]

I am located in Eastern PA near Philadelphia.

The best I could do for now on the cam specs are a follows:

HR-260-12-210 0.050

This decodes to:
260 advertised duration
112 degree centerline
210 duration at 0.050" cam lift

The best guess they have on lift is about 0.490

I'll see if I can degree it this week sometime.

[trotterlg]

Is this a solid core cam? Larry

[bszopi]

Is this a solid core cam? Larry

In the other thread, he says its a regrind on a stock cam, so I would assume that it is a hollow core.

EDIT: Pictures 53 and 54 from the above link confirm this.

[NateD4]

This is a stock regrind the best I can tell.

[NateD4]

Here are the pictures of the block.

http://img846.imageshack.us/slideshow/webplayer.php?id=dscn1001n.jpg