If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
proceed to the Forums area and select the forum that you want to visit.
What do you mean by that? I could take front engine cover a bunch of ways. I probably have one that I'd be willing to part with though... Are you talking about the whole aluminum casting that houses the timing belt and all?
3.4 DOHC- 95 engine, custom intake manifold, custom cams, ported exhaust manifolds, Turbonetics T-62, Haltech standalone, 13.5 psi, air/h20 intercooler... yadda yadda...
1987 Fiero, ST lowering springs, KYB's, Clutchnet dual diaphragm 6-puck, custom paint, 18's with falken fk452 225 front Nitto NT05 245 rear. Should be around 450whp...
What do you mean by that? I could take front engine cover a bunch of ways. I probably have one that I'd be willing to part with though... Are you talking about the whole aluminum casting that houses the timing belt and all?
Yes the cast aluminum piece that holds the waterpump a/c alternator timing belt and covers the timing chain
are you selling the intakes off the 96/97 motor? I'd like a price on the upper shipped to 60401.. thanks
Robert
--------------------------------------------------- 96 Grand Prix SE 3100 202,000 miles
New Rebuilt 3100
New Rebuilt 4T60-E
Exhaust
Drilled/Slotted Rotors
95 Grand Prix GTP 177,000 miles
White
3" Magnaflow Catback
Lowered 2" Eibach in front Brichmount Rear
94-96 Hi-Po 5 Stars on 245/50/16
90 Pontiac Turbo Grand Prix
5 Speed Swapped
127,000
Spec Stage 3 Clutch
230,000 mile Getrag 282
Emissions Deleted
Brand new Engine 1,000 Miles
Fully Custom Built car
Well that cast aluminum piece I could part with. Make an offer. It's the brand new one off my crate motor.
As for intakes, I do not have a set of 96-97's. Crate motors don't come with the intake manifolds. You can still get a brand new upper intake from gm though... 175 bux
3.4 DOHC- 95 engine, custom intake manifold, custom cams, ported exhaust manifolds, Turbonetics T-62, Haltech standalone, 13.5 psi, air/h20 intercooler... yadda yadda...
1987 Fiero, ST lowering springs, KYB's, Clutchnet dual diaphragm 6-puck, custom paint, 18's with falken fk452 225 front Nitto NT05 245 rear. Should be around 450whp...
Comment