Announcement

Collapse
No announcement yet.

3400 upper and lowwer intake plus more

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3400 upper and lowwer intake plus more

    I have left over parts from a 3100 to a 3400 swap.hate to throw away.if you pay shipping will let it go CHEAP.call 8158715084.both intakes up and low with t body,rear exhaust manifold.

  • #2
    What year?
    Ben
    60DegreeV6.com
    WOT-Tech.com

    Comment


    • #3
      both came off same motor dont pin me down to year specific.replaced motor in a 1997ga 3100 was told the motor came out of monte carlo,if I not mistaken monte didnt have a 3400 till 2000 .so its 2000 or newwer anyway?was at work when I replyied back by looking in my email. you figure out shipping arangements 61115 northern ill rockford area.100.00.oo inclds.all inj with haness egr with harness but it looks like it was cut up but all the connecters are intact.also came with trans .not sure the transtype but its the one that you check fluid level without a dipstick[pulling side plug out]injectors are the newwest stye connecters ,different than old multecs.tell me what you want then we both could figure out shipping.
      -----Original Message-----
      From: Ben <admin@60degreev6.com>
      To: limo65@aol.com
      Sent: Thu, 6 Nov 2008 5:09 pm
      Subject: Re: Reply to thread '3400 upper and lowwer intake plus more'


      Does the lower say 00 on it as well? How much for both shipped to 46582.

      FYI, responding to the emails just sends me the message, not the forum.

      Ben

      limo65@aol.com wrote:

      Comment


      • #4
        usps.com is how I ship and from illinois it won't be much at all since I am in indiana. I don't want anything else besides the upper and lower intake.
        Ben
        60DegreeV6.com
        WOT-Tech.com

        Comment


        • #5
          reply

          I will weigh it at work let you know what it weighs.are you sure you dont want it all because I have no use for it.think 75 for it, is fair?

          Comment


          • #6
            Ben doesn't want the TB for the linkage? Must be stock piled !
            sigpic New 2010 project (click image)
            1994 3100 BERETTA. 200,000+ miles
            16.0 1/4 mile when stock. Now ???
            Original L82 Longblock
            with LA1, LX9, LX5 parts
            Manifold-back 2.5" SS Mandrel Exhaust. Hardware is SS too.

            Comment


            • #7
              Ill give you 25 for the egr and rail and injectors and tb and wiring plus shipping. When you said manifolds for cheap cause you were throwing them away, I didn't anticipate having to buy a bunch of other parts, or that you would value the manifolds that much.
              Last edited by SappySE107; 11-06-2008, 11:38 PM.
              Ben
              60DegreeV6.com
              WOT-Tech.com

              Comment


              • #8
                just threw that figure out.howmuch are you offering?lets make it worthwhile please.the harness for injectors is intact. the harness that has egr cant speak for
                Last edited by limo65; 11-07-2008, 04:46 PM.

                Comment


                • #9
                  Ill give you 100 shipped for the upper intake, lower intake, and throttle body. Shipping isn't that much from illinois.
                  Ben
                  60DegreeV6.com
                  WOT-Tech.com

                  Comment


                  • #10
                    ill think about it but it sounds good to me depends what it going to cost to ship

                    Comment

                    Working...
                    X