Wanted Cylinder Heads 3.1 TBI

[McLin]

By Carfax stand this:

VIN 1GNCU06D8LT11****
Year/Make/Model: 1990 CHEVROLET LUMINA
Body Style: SPORTS VAN
Engine Type: 3.1L V6 MPI OHV 12V
Manufactured In: UNITED STATES
Search Results: 1 record found in our database

I need for this Engine Cylinder Heads....

[IsaacHayes]

Are they iron heads? If so lots of 2.8/3.1/3.4 RWD heads would fit (all same)

[McLin]

I found this on:

Rebuild

FWD, APV, Transport, block #653, 519, crank #981, cast iron heads, with distributor.

[2.8RS]

I was going to say that a set of heads would be easy to find in a junkyard but I see that you are in Germany. But check out Ebay, there is usually a few heads for sale on there.

[ForcedFirebird]

I have a set that came off my 3.1 and were running strong (blew the bottom end from turbocharging).

I'll let you have them for a reasonable price, but shipping would be expensive.

[SappySE107]

I knew you would have a set:P

[ForcedFirebird]

I knew you would have a set:P

Actually have a couple, but the other set is no better than boat anchors, lol.

[SappySE107]

I need to flow the iron head with and without the complete manifold setup someday.

enough of the off topic though:P what would it cost to ship a set of heads to germany? I dunno what they weigh.

[ForcedFirebird]

I need to flow the iron head with and without the complete manifold setup someday.

enough of the off topic though:P what would it cost to ship a set of heads to germany? I dunno what they weigh.

A complete iron head top end weighs 84lbs IIRC, then you can subtract about 14lbs for the manifolds.

I Could send you a head and manifolds if you want (the junk ones will work), but I already have flow numbers for stock and SuperSix porting - thanks to turboproject...

http://www.fullthrottlev6.com/forums/attachment.php?attachmentid=1904&d=1211150860

[1988GTU]

Shipping will be about 150.00 IIRC. lbs + size of those heads just adds up.

[SappySE107]

I can get a head local probably but could use manifolds. Nice to see those numbers are close to mine. 3.4 DOHC pwns on the bench.

[ForcedFirebird]

I can get a head local probably but could use manifolds. Nice to see those numbers are close to mine. 3.4 DOHC pwns on the bench.

Probably because some of them ARE your numbers

[SappySE107]

oh. well then nevermind:P I like comparing off the same bench cause each setup is different. I use a tube for the exhaust and if you don't, those iron head 3.4 numbers look realistic for gen 2 for the most part.

[bszopi]

IIRC, he is coming over to the states in a month or so, so he could pick them up and take them back on the plane with him.

[1988GTU]

^ Don't you mean Weba is?