Copper Head Gaskets

[tejohnson]

SOLD.


Copper Gaskets from Gasket Works - http://www.headgasket.com/





.070" Thick
3.750" Bores

Stainless steel O rings included, attaches to the gasket with copper spray. No need to ring the block.



These were installed temporarily, however, I changed my mind after running the engine for about 30 minutes since I did not have the patience to re-torque my head studs, so I went with the Graphite gaskets.

I cleaned off the copper spray, and annealed them. The buyer may want to anneal them once more prior to installation.

Installation instructions: http://www.headgasket.com/preinstall.html

Now on eBay: http://cgi.ebay.com/ebaymotors/ws/eB...m=320257895484

[tejohnson]

Now on eBay: http://cgi.ebay.com/ebaymotors/ws/eB...m=320257895484

[tejohnson]

It's kinda funny, I see that people are "watching" the item through eBay, but nobody is bidding. I suspect folks intend to do a last minute bid snipe to snag them for $125...

[tejohnson]

24 hours left on the auction!

[Canyonero]

Why did you change your mind?

[tejohnson]

At the time, I didn't have it (time) to fool with them (to re-torque, stop leak, etc), because I was in a hurry to get wrapped up for the Pontiac Nationals in Norwalk Oh.

[tejohnson]

Less than 2 hours! It is very unlikely you will find these again at this cost.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=320257895484

[tejohnson]

Re-Listed. Starting bid is now $100.00.

[tejohnson]

Nobody?

[tejohnson]

Re-Listed. Starting bid is $65.

[tejohnson]

7 hours remaining. They will certainly not be re-listed, and the price of $65 will not be lowered, since that would simply be an insult. I will likely add them with the "extras" that will go with the short block.

[tejohnson]

SOLD.

[bszopi]

About damn time...

[Z26-T]

Aw... If i knew they were for 65 i may have done it