Custom ground cam and pushrods

[silvergtjrad]

I bought a cam back in august, intending to put it in the motor thats currently in my car. After much deliberation, I decided to do a full, out of car, build up and go the route of a turbo rather than N/A. Seeing that the cam isnt well suited for a turbo application, its pretty much of no use to me. It is a 1615 grind from the 60*V6 store, along with the custom length pushrods made for the cam. The cam was $310 and the pushrods are $135. I'll entertain any offers made.
Check out this link for the grind specs and simulations->http://www.60degreev6.com/store/imag...V6regrinds.htm

[merlot566jka]

got valve springs too?

[silvergtjrad]

got valve springs too?

Yes I do, but im keeping them for my build.

[silvergtjrad]

Bump.

[silvergtjrad]

bump. This would be a nice Christmas present to yourself!

[ForcedFirebird]

"Page not found" from your link.

[MY91GT(Z)]

what stg cam is it i may be interested if it somewhat compares to his 1280 cam grind

[silvergtjrad]

Forced-> fixed the link
MY91GT(Z)-> check out the link, ben has the simulations done for the grind im selling (1615) and the 1280 grind.

[silvergtjrad]

Bump. I'll do $375 shipped for the cam and pushrods in the lower 48. Pick it up and its $350 This would cost you $445 new from the store here, plus shipping, the time it takes to get the cam ground, and ben to measure and fabricate the custom pushrods.

[94GPGTP]

will this fit the 3100??

[silvergtjrad]

will this fit the 3100??

Yes, it will fit the 3100. I forgot to have this thread taken down though. Ive decided to abandon my turbo build and go with my original plans. Money is just too tight at home right now. Rather than delaying the build forever, im just going to get another set of pistons and call it a day.

Can a mod please lock or delete this thread?

[94GPGTP]

so just asking...its not avaiable then?? im only an hour from you..