Tweet
I need some 3400 pistons (stock size). Don't care if they are stock, as long as no damage. On rods wouldn't hurt either, unless the shipping is too much.
Thanks
.
Thanks
.
-
-
Nevermind, I had a brain fart for a second.... -
How soon do you need them? I'll be tearing apart my 3400 and wont need the stock pistons. It might not happen until the middle of july though. Too late?
The rods I'll need unless plans change.
Comment
-
Not too late, the 3.4 won't be here until next week at the earliest. Once I get the motor here, I'll take the first set I can get my hands onOriginally posted by Chris88CL View Post.
Comment
-
i have a set of 3500 pistons if ur interested hit me up94 BerrettaZ26 3400,5 spd, aluminum flywheel, stg3+ spec clutch, poly mounts everywhere, strut and strut to rad braces, s&s headers, euro mirrors, and taillights, E36 headlights, blk widow spoiler, GTU rimz, intrax, KYB, OBD2 swap rear disk swap with ss lines and ss clutch line, addco rear bar
07 Chrysler 300 Base, with C frt bumper blk halo headlights and foglights. Coming soon tinted taillights and 22". The Family ride
Comment
-
ForcedFirebird shipping wont be much for the fully assembled pistons. just an FYI. it only cost me like 20 bucks to ship 6 complete pistons. i shipped them ups too.
just a tip for whoever you buy them fromsigpic
99 Grand Am GT
3400/3500 -Solid trans mount--TCE 65mm T-body---85mm LS2 maf---1 1/4' TCE intake spacers with 3400 upper--SLP Catback with flowmaster 80--TOG headers
Modded 3400 lifters with LT1 springs---Comp Cams 26986 Springs
1357 cam 227 233 .050 dur 515 515 lift 112 lsa
15.232@88.85mph on stock 3400---New time to come
Comment
-
I have a set of 5 incl.rods
you can have them for 50$
don't know if thats sufficient(only 5) ?
only down side is that shipping would be a bitch (europe)
gr.bjorn
nothing's impossible-it's just a mindsetComment
-
Will they fit in a 3.4 block (and on the rods), and do you know the dish size?Originally posted by MY91GT(Z) View PostComment
-
No, I need all 6Originally posted by bjornmk1 View Post. I'm converting a 3.4 to a hybrid.
Comment
-
okay.
use the CR calculator to see how much cc's the dish is
on the 3400 engine.
good luck,bjorn nothing's impossible-it's just a mindsetComment
-
I know the cc's for the 3400, but not the 3500 (the 3500 doesn't have any values in the CRCalculator yetOriginally posted by bjornmk1 View Post).
Comment
-
I have a set of the guy that was going to buy the short block falls through. I would have the pistons and the rods and would sell them to you for $125 shipped....I will let you know on Sunday for sure if you could have them. Let me know if you are interested.Marc
Comment
-
-
Yes still have them. they are sitting in the block still, but I could pull them basically any night.Marc
Comment
-
I've got all six on the rods if you're still looking for a set. I'd like to get $100 shipped. Shoot me an email if interested. I take Paypal.Comment
Comment