Tweet
has any1 ever put a set of 3.4 dohc heads on a flow bench? i done some light reading and am relatively new to some of the more technical stuff like this. but i figure the 1st step in regrinding cams would be to have some flowbench data to see what these heads can do so no1 overkills the cams, porting, custom intakes etc...
or the data could be used to build the some real high end intakes/cams etc... lastly, i assume this data would be useful in building the torque curves that peeps want.
b/c i am thinking if you have the flowbench data, you just hand it to chrfab and tell them to do a good regrind and they will have a better idea on what exactly to do every1 wins.
the big question who has a flowbench and who has extra sets of heads laying around to test.
or the data could be used to build the some real high end intakes/cams etc... lastly, i assume this data would be useful in building the torque curves that peeps want.
b/c i am thinking if you have the flowbench data, you just hand it to chrfab and tell them to do a good regrind and they will have a better idea on what exactly to do every1 wins.
the big question who has a flowbench and who has extra sets of heads laying around to test.
Comment