Tweet
nope - wouldn't interfere at all
-
-
Received my cam tool today. SWEET!!!!! Very nice work!
Thank You1997 Z34 Monte,: testing 4 exh cam\'s, RSM STB, K&N, Eagle077 245/40/ZR18 Nitto Extreme
1972 3/4 ton 4X4 longbed, built 350, 400 auto, 6\" spring lift, 35\" AT/BFG\'s, dana 60 front axle, 14 bolt gm w/detroit locker 4.56 gears. My ricer smasher
Comment
-
I hope the directions explain it well enough. I haven't timed a motor yet without stock timing but did test it out on a head/cam setup out of the car. Its a bit of effort to move the cam but its not too bad. The cam will also sit where you need it unless you go to 10 or 12 degrees. I don't think we need that much but who knows, maybe there is someone that needs 20-24 crank degree timing changes.Ben
60DegreeV6.com
WOT-Tech.comComment
Comment