Tweet
An itb intake is also in the works for the 3.4 Dohc in my fiero
Sent from my XT1080 using Tapatalk
Sent from my XT1080 using Tapatalk
-
-
i've read a hundred people's threads claiming to have them in the works but never following through.
please be the exception to the rule, i REALLY want to see how the LQ1 reacts to ITBs.Comment
-
Well I have six extrudabody 52mm to 50mm taper bore throttle bodies and the flange is already cut to bolt to the lower manifold. I'm going to criss cross them three above each valve cover. And then run two plenums with a filter under each "over roof scoop" of the fiero
Sent from my XT1080 using TapatalkComment
-
Unfortunately, the VW head stud kit I found didn't work on the 96 heads I have. I suspect that any head stud kit would require someone to make all of the required measurements and then order directly from ARP or someone else. IIRC, one of the Fiero guys was using a head stud kit he pieced together.
Tim1995 Z34 - T04E "60" trim, 42.5 lb/hr injectors, AEM WBO2, FFP UD&DB, 3" exhaust, 2800 stall, shift kit, tranny cooler, Powerslot, Hawk HPS, rear disc conversion, KYB, Eibach, HMS F&R STB, Fittipaldi Force 18" wheels, big stereo, lots more coming eventually...
325 whp 350 lb-ftComment
-
anything new here?"I am not what you so glibly call to be a civilized man. I have broken with society for reasons which I alone am able to appreciate. I am therefore not subject to it's stupid laws, and I ask you to never allude to them in my presence again."Comment
-
I used raceware's head studs for a M20 BMW, I had to call and order to get an extra 4 studs (and nuts and washer) as I recall. And I had to shorten them .200" to clear the cam carriers.sigpic
Fiero gt 3.4 DOHC turbo forged bottom end MSII
94 Ranger 2.3 turbo t5 (DD)Comment
-
We sell M20 head studs, and they won't fit a 60V6 block. M10 vs M11.Ben
60DegreeV6.com
WOT-Tech.comComment
-
My apologies, I recalled wrong.. special ordered...sigpic
Fiero gt 3.4 DOHC turbo forged bottom end MSII
94 Ranger 2.3 turbo t5 (DD)Comment
-
He's still working on it, but he's looking at moving a couple of hundred miles away and trying to figure out what to do with all his junk... LOLOriginally posted by ericjon262 View Postsigpic
"When you don't do anything, you have plenty of time to post questions that don't mean anything tomorrow."
- BenComment
-
Thanks nick. Yes I am still working on it. As of now this is where it stands. I have put the motor into my Fiero and hooked a getrag 282 5 speed to it that has a ep LSD in it.
Comment
Comment