Ever seen this??

[Jaysin]

I am tearing down my old cylinder heads today and I noticed that one of the valve guides was higher. When I measured it stood .709 off the head. The one right next to it stood .58 off the head. All I can imagine happened is the guy I got the car from let it overheat and that allowed the valve guide to move. Now I have to figure out how to get them all the same height agian. Any suggestions? I don't have a torch so that can't happen...

[Doubt_Incarnate]

if you have an old valve or a bolt, you can put that in from the top and try to tap it back down