Announcement

Collapse
No announcement yet.

HELP !!!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • HELP !!!

    I first started my car with my remote starter , with ho problem the car started normally . But in the car , i noticed that the idle was fluctuating a lil bit more than usual , and after , i tried to put the car into reverse and back up , but the car stalled . I restarted it , put it into drive , and make it back to the sideway , but when i pressed the gas , thre was not much power , like i need to push the pedal really far to get the car go forward . I pop up the hood , and the engine was shaking more than usual . I put the Rpm to 1500 - 2000 during 15 seconds and the engine was doing well , but when i released the throttle , the engine stalled and i never got it back on . What the fuck could it be ? I boosted my friend car last night , but the car was doing well after that anyway . My amp meter is at 3/4 , and everything works fines besides that stalling thing . I got prestone , at normal level , i got heat , and gas . wth? the car is not bruning any prestone at all , and not loosing some too ... i cant understand .


    Engine + Tranny = Original
    Km = 314000
    Number of 3.4 badges on the car = only one
    Sleeper = Yes

  • #2
    Sounds like the timing belt is toast. Most go out under cold start conditions, not at running temp as most think. I would check that first. 1 question, does it turn over funny?
    If you are driving a Chevy, everything else, is just a blur. 3.4 Carbon Footprint.
    sigpic

    Comment


    • #3
      As usual ... the belt as been done this Fall . It started , but stalled normally . i still got some fire , i checked my oil and prestone , and they re all ok


      Engine + Tranny = Original
      Km = 314000
      Number of 3.4 badges on the car = only one
      Sleeper = Yes

      Comment

      Working...
      X