Crane Gold Race 1.6:1 Roller Rockers

[SappySE107]

I should have a couple sets by the end of the month and will have them on the store. Price will be $345 for a set of 12 with studs. If you want a set I can pre order them now. Just PM or Email me.

[SappySE107]

http://60degreev6.com/store/index.ph...d&productId=38

added them to the store. Im not home as you can read on that link so I will have more information on them tomorrow.

[Manitcor]

awesome, ive been wating with baited breath till they made another run of these. :woot:

[Darin]

Which price is correct? $345 that is stated here. Or the $245 stated in the store?

[SappySE107]

Thanks! That was a typo on the store. They are 345. Wish I got them cheap enough to sell them for 245.

[Darin]

Wish I got them cheap enough to sell them for 245.

Me too I would order 2 sets

[farmerz24]

do these feature crane's quick lift technology? also 3/8 or 1/2 stud?

[SappySE107]

I dunno what quick lift technology is but they are 3/8" stud with 10mm on top. There is a link to cranes site on the 60V6 store page for these rockers.

[Guest]

I have been trying to sell a set of these for only $200.

[SappySE107]

Are they new with studs?

[19Cutlass94]

well it says it will fit 80-94, so hopefully itll fit mine, but yet I do have a couple questions.

Like it says in the store, you have to test fit these on certian heads, for the 3100 head, all I have to change is the stud correct? Also, will longer pushrods be needed or will the stock ones work? ( if I get these Ill get cromoly sp? pushrods ) And another issue could be with the valve covers too?

Id really like to get these, but if theres a problem, Ill have to go with the roller tip rockers...

[farmerz24]

quick lift technology is found in the ls1 rockers, dunnno if the 350 ones apply or not, but it basically acts like a 1.8 or 1.7 for the first little bit getting the valve open sooner.

basically increases your .050 duration without increasing your total duration, therefore more power, while still maintaining overall duration for driveability.

[geoffinbc]

well it says it will fit 80-94, so hopefully itll fit mine, but yet I do have a couple questions.

Like it says in the store, you have to test fit these on certian heads, for the 3100 head, all I have to change is the stud correct? Also, will longer pushrods be needed or will the stock ones work? ( if I get these Ill get cromoly sp? pushrods ) And another issue could be with the valve covers too?

Id really like to get these, but if theres a problem, Ill have to go with the roller tip rockers...

Cranes roller rockers clear all valve covers on the 660 motors. Except Fiero's which only need a tiny amount take off the corner of the rockers. The 3X00 motors require lower intake clearancing in order to fit. Gen I and II are a bolt in mod.

[SappySE107]

Stock gen 3 rocker arm without the bolt/stand weighs 156.2 grams. Crane gold race rocker weighs 138.4 grams. Thats almost 12%

[95SleeperAcheiva]

Will they work in a 2004 3.4?